One set of machine can production round pipe, square &rectangular pipe and parts ofabroach cold rolled section steel.

1. ZTF forming method in producing round pipe:

1)Save 60% charge on rolls reserve

2)Before the closed pore, one set of roll can be used to produce any size of round pipe within the

Range. Only the rolls after closed pore need to be replaced.

3)Reduce production time

4) Easier to restore rolls

5) Convenient to restore and adjust

2. Directly square forming technology in producing square&rectangular pipes:

This way is to directly roll the steel strip and bend it to square&rectangular shape, then weld to

Finish the formation.

Charateristics &Advantages:

1) Compared with round to square forming method, this method can make: Better shape of angles

For cross section, smaller semidiamer of inner arcis, flatter brim, regular outlook.

2)Low load for the whole line, especially in the sizing part

3)2.4-3% strip width shrinkage than round square forming method, so that to save raw materials

4) Advance multi-point bending, avoiding the axial force and side abrasion, reducing the forming

Step and ensuring the quality, meanwhile reducing power wastage and roll abrasion

5)By combined rolls, one set can be used to produce lots of square&rectangular pipes with

Different sepcifications. This can decrease the storage of rolls, lower 80% roll cost, fast the

Bandroll turnover, shorten developing time for new lines.

3. Produce parts of abroch cold rolled section steel:

Simple abroach cold rolled section steel such as directly formed channel steel, C shape steel, Z shape steel. The rolls can be basically shared with dierctly squre forming method.