automatic transmission car in urban driving, if the speed can not surpass 60 km / h, it is necessary to use a gear lower than the D file, so can build up the sharp, and to avoid the product of coke; when the speed of more than 60 after the file using the D drive, not only fuel, it will not undermine the acceleration. In mountain driving, according to the position will must use 2 files or a file, in addition to retaining a strong torque output, the engine braking effect would prevent excessive use of foot brake to ensure road safety. Automatic transmission cars do not have the D-file feature of engine braking, and will continue to amplify as the downhill speed to high-speed gear change, make the speed faster and faster, we must often use the foot brake to control speed, it is effortless to arising from the use of excessive brake heat failure, which is very dangerous. Therefore, the automatic transmission driving the car to go a long downhill, the file must not use the D drive, in case of crisis. Even if you purchase automatic car shift the purpose is to dispense with the trouble, but also a little hard-working point. At low speed, for the following file into the D gear, high speed and then rest guaranteed, the easy way to use the D file boldly going forward. I would have a good multiplier effect.

9, so when the red light, in the end file should be used with N or D file, according to their habits, slam the brakes to temporarily stop hanging in the D on there is no damage to the car, because the gearbox has a torque converter one-way clutch with the repercussion cycle, whose role is to distend the torque from the engine crankshaft, the engine idle speed is not rotating, only until the engine speed rises it will work. So when you slam the brakes are not narrated to red light,购买诺基亚手机须知, pull the hand brake is also linked to N anyhow. In common, more than half a minute if you stop hanging in the N pull the hand brake, stopping a short time if it is stepping on the brake, etc. just fine.

4) automatic transmission car in motion must not be pushed into the P file. Change in the direction of travel, D and R file to switch file must be parked vehicle before making such operations.

3, the car starts to go, only the brake drive, before the shift lever from P or N files out of the file, change into running gear. Release the brake pedal, the car can voyage up slowly. The reason the brakes in advance is also aimed at drivers and vehicle safety. Otherwise, the engine starts, hang forward gear, the car move occurs, if the driver reaction time is not enough, it is disposed to collisions;

2, using N file start: When you begin the vehicle after driving amenable directly without reversing, you can first connect the power, step Push the brake to gear housing to N, then the ignition, and then be put on the D file directly forward, to avoid sparking in the P file, you need through the R file,sale karen millen, so that transmission via a reverse shock! Another role is to suddenly rotate off when in film, you can ensure the safety of the stalls fast shoved to the ignition and then start the engine stalls N;

7, because the automatic transmission with a hydraulic transmission, and fluid flow has a certain inertia, it can not suddenly change, so it is best after a parked car, and then linked into reverse gear. Complete stop before the vehicle is not absolutely prohibit the shift lever into the P file hanging. After stopping,blazer mens, you must turn off file can hang out into the P key. Many people used to stop and pushed directly to the P file then turn off, pull the hand brake. Observant people will find that you do so, turn off the vehicle deserving to uneven pavement after the general will move approximately a little bit, and then have a bite P-speed gearbox and the gear appliance is a bite, and when the move will result in gear little shock! The correct way is: car into the parking position, the gear stick to slam the brakes N file, pull handbrake, release the foot brake and then turn off, then eventually push the gear lever into the P file! Of course, this excellence is also part of the protection of the gearbox;

automatic loose about what can be achieved scale up a gear at first the right (but must prefer a good step, loose time), but at the expense of speed circumstances to achieve a relatively fuel-efficient purpose, does not make the vehicle expedite faster. When the more and more to shift after the interval, at the peak of the light you near the throttle, automatic transmission automatically upshifts to the directions you received the oil in the moment of engine speed will drop some, fair up a gear in the tooth than just assembly,puma women, which again when the fuel line ahead, you will find the plenary shift process even more smooth, more cozy ride.
* Note: to achieve early upshifts, and then step on the gas when the degree is not also massive, otherwise the transmission would think that drivers need to hard acceleration , while the current gear can not meet the requirements of the power output automatically downshift, back to a lower gear, causing bound file! This car fans can test the operation several times in the master control of his vehicle transmission scale.
1 / 2 files (restricted file) when the 2 works, that is,杯酒人生, uphill and downhill by the time. First is uphill, if steep, can be put on 2 or even 1 to complete the ascend and then correlated into the sprinting files to natural vehicle. Downhill while the file is limited to use as one auxiliary stop, we all know thatdriving manual transmission car in the mountains, down a long incline, the slope (the course is not essential Xiao-Po beneath the operation of such) can be hung in a lower gear for one assistant stop, meantime the automatic transmission in the D file when there is no auxiliary braking efficacy, the more it will slip faster. At this time restrict can be put above file, to fulfill additional use withdrawal stall the engine as a brake with auxiliary braking to depress brake pressure of work.

solution of the two, obtain rid of the habit of the D file in the end, the correct use of automatic transmission,ugg boots mens, the habit of changing a file in the end. Many automatic models in addition to the D file, there are 1,2,3 file. Urban speed slow when the file can be stalls on 2 or 3 files, 2 mountain is on file or a file, you will find that it seems mark new car, running up and not merely powerful, and more light. Some people may doubt that such operations will have an detrimental effect on the transmission system? Will more fuel? The response is not working to, but also more favorable. Because, since the variable speed system design of these stalls, it manner that they each have their Division, the correct operation will not occasion abuse. At the same time, a higher gear to shirk dragging vehicles, oil expense will be lower leap, but also reduce engine carbon phenomenon. This does not tug files to a strong notion of landlords manual.

automatic vehicle driving skills

1, the engine is started, automatic transmission also have been restricted to the stalls, this is a plant for security reasons while the gearbox adjustments made. Generally only when the shift lever in gear position P or N, we can start the engine. If the gear shift lever in motion, such as D, R and additional places, the engine can not start. The purpose of this restriction is to prevent the car collided with an thing before and after. If the novice will not start the engine, you should first check is not linked to the wrong file. If the file is not a P or N, you should adjust, and then start the car;

5) driving end of the parking: car into the parking situation, slam the brakes pluck the shift lever to pull the handbrake N file Release the foot brake and then turn off the shift lever into the P file pull the key!

under normal driving shift automatic transmission in the 2000-2500 rpm range. If you are massive on the throttle, the transmission will automatically shift the postpone time, tall power output as a long time, usually after 3000 will ascend in the file, the circumstance will all tread into the red zone was subserved to more and more the next file (which basically set the file instead of the character of S). On the inverse, if you step on the gas the transmission will sabsent from the 1st speed less than 2000 when subserved to the next file, with the driver in array to achieve the ambitious and purpose of fuel economy.

1) only in P, N two steps when you can launch the vehicle, elect a file from the P shift lever must slam the brakes. N file is when you start to use directly after launching the vehicle moving forward, you can first power (not the name of the engine), slam the brakes pulled the stalls N, then the ignition, and then file a straight link into the D forward, to avoid sparking in the P file, you need to bring an end to ... R file, so that transmission through a reverse shock! Another role is to suddenly turn off when in motion, you can ensure the safety of the stalls quickly pushed to the N file ignition and then start the engine.

Notes

3) moving into the N files must not hang glide, because the automatic transmission needs lubrication, when moving the gear on top when N oil pump is not properly lubricated, and make the internal transmission parts temperature, resulting in complete damage! Another gap is the sliding speed is very dangerous, and not fuel efficient! Slide the stop to advance the low-speed link into N files, is no longer any effect.

solution, 1 without considering the premise of fuel, car is usually started with the throttle. Now most of the automatic vehicle speed program has learning function, if you step on the accelerator pedal too deep, the procedure will automatically change the original variable-speed shift points. For sample, the original setting is 2500 rpm upshifts, and will use the throttle at 4000 rpm or more before upshift, so the actual output torque of the vehicle is much larger than before, the vehicle's power is stronger. If you often use the throttle, automatic transmission program will memorize your driving habits, automatic transmission shift points will change the factory both power and energy-saving settings, automatically upshifts point increase in engine speed. Also, if your car has amusement mode setting, select Sport mode operation, it will have the same effect.

automatic

8, long-stay parking must use the hand brake, automatic transmission, otherwise it will damage the locking machinery. P files and files of the difference lies in N, P file when there are transmission gear engaged, it is not only used for parking, and will help braking,spyder jackets outlet, in the parking stalls after going to push to P file, not hanging in the mow N files rely solely on the hand brake to brake,[ Turn ] a nice post on Japan! Especially in the more sloping parking location should be so;

automatic transmission car use

5, moving into the N files have to not hang glide, because the automatic transmission needs lubrication, when moving the gear on altitude when N fuel pump is not properly lubricated, and make the internal transmission chapters temperature, resulting in complete damage! Another high-speed sliding breach is very dangerous, and not fuel effective. Slide the stop to advance the low-speed link into N files, is no longer whichever effect;

4, in moving forward gears can freely switch. Although these limits can stall the maximum gear, but at the peak of the gear and speed mate, you can freely switch;

automatic transmission system is designed so that D can stall speed automatic in the 3-2 (or 3-speed automatic 4-speed auto) or 4-3-2 (5-speed automatic transmission car) file to automatically change. This design, in the case of urban stop-go, automatic transmission will be in the 3-2,2-3 or constantly changing between files. Acceleration of the vehicle depends on the performance of the engine torque, manual control of the car owners can point shift in the most torque output, and automatic transmission shift the car moves up and down frequently makes the driver feel the car of course, the performance of . This situation continues to be more manifest on the downhill segments.

6, the process of moving the vehicle must not be pushed into the P file, unless you do not want the car. Need to change the intention of travel, be sure to await before production a parked vehicle switch gear;

6) Temporary parking (such as red light), N-, or D are not wrong, according to their habits can be, if the parking in the semi- minutes or more you hang it into the N pull the hand brake.

2) usually stalls the N, D, 3 when the switch among the button without urgent the shift, from 3 to hang down the restrictions necessitated at file shift handle, hung from low to high do not reception the shift clasp.

automatic transmission driving all the way in the end is not the D file

automatic transmission and manual transmission systems are two completely different chart, both in adding to the same final purpose of work, the rule of its operation and performance way is not the same. Although the automatic driving is very simple,uk ghd straighteners, but if we absence to have handy automatic transmission traffic, it requires a definite capability. In methodology, whether it is manual transmission or automatic transmission, If the correct way to manipulate, should have similar performance. The car feels as good as manual automatic cars muscular, primarily for of operation does not.
accustom handbook drivers ordinarily know the best time to shift with them more handy. Available auto displacement automobile, folk constantly are no very nice, often simply use the D document, all the way in the end. This namely considered the most exact automatic car driving usage, however no erroneous, but later finding the consciousness of relaxed pedaling, merely can no help merely feel that it is insufficient taste, it seems that the overall performance is all less in the manual of the car. This is not true, there is a lot of use there are problems. If you use the correct control mode, automatic displacement cars ambition too must manually override the file's performance.

narrow files can periodically use as a kickdown, that time you need a strong torque output, you can use it to control the gear more achieve low morsel up or overtaking, you can pull down the stalls. However, based on your automatic transmission is to decide whether the degree of throttle downshift, for instance, in front of you super slow, you can loosen the throttle first and then a foot down, then the gearbox will automatically drop a file or 2 files to meet your power requirements, the completion and unlock the throttle overtaking, return to your current gear will stall speed right, in which case you no need to use restricted files, use the throttle to control the light on it .